ActSafe PME Guía de usuario

ActSafe PME 4-stroke engine User’s guide WARNING! All potential users of this equipment and users management must be read and understand the i

10 TRANSPORT AND STORAGE - Carry the ActSafe PME by the handle with the engine off a

11 STOPPING Gradually decrease the engine speed to an idle speed, and then slide igni

12 This method is mostly used during work on open framework structures and towers. Th

13 WORK TECHNIQUE Below is a detailed description of work technology as well as requ

14 The anchorage point must have a break load of at least 15kN. Karabiner, harnesses,

15 - Start the machine whilst still placed on the ground. Check the power supply wit

16 ALTERNATIVES As mentioned above, the line thrower may be used to bring a permanent working rope for initial ascent to its posi

17 5. Release the rope from the machine’s rope grab (the safety device is now formed by the TIBLOC which is attached to

18 7. 7. Disengage the TIBLOC and begin the descent. This technique is also employed when the machine is used to a

19 ACTSAFE PME IN RESCUE OPERATIONSThe ActSafe PME also functions as a source of powe

2 NOTE! Fuel >95 octane 4-stroke engine

20 RESCUE OF COLLEAGUES FROM FRAMEWORK STRUCTURES Where ActSafe PME is used in worki

21 Alternatives to different set up

22 SERVICE AND DAILY INSPECTIONS The machine has to be maintained and serviced accor

23 SPARK PLUG The spark plug condition is influenced by: - A dirty air filter. - Har

24 THE ROPE GRAB It is normally not necessary to remove the rope grab for inspection unless it has been exposed to abnormally dusty or

25 ENGINE WARRANTY Act Safe Systems AB is pleased to assume warranty obligations and apologies for the trouble caused to you. All authorised dealer

26 REGISTER AND YOUR COMPANY CAN EXTEND ITS WARRANTY PERIOD FOR ONE MORE YEAR. Register by writing a mail with subject “Registration of ActSafe PME

27 Guarantee General conditions ActSafe is responsible for the proper function of the product during the guarantee time period. If a defect is detec

28 WARNING! The ActSafe PME should only be used so that the rope has an anchor point straight above the position of the user. The anchor po

29

3 Thank you for choosing a product from Act Safe Systems AB®. This machine, correctly used, will provide you with the ability to perform your work

30

31 SERVICE CARD ActSafe Serial No: Year of manufacture Date of purchase Date first put into service Name of owner Date of se

32 Specifications for ActSafe PME The ActSafe PME is the basic product in a working method developed by Act Safe Systems. The method, together with

4 The motor must not be operated before these safety instructions have been read and understood. Read this guide carefully as well as the instruct

5 Definitions 1. Accelerator Handle 12. Top hole for fastening the rope/carabiner 2. Spark Plug 13. Lower hole, NOT FOR LIFTING! 3. Sw

6 SAFETY PRECAUTIONS If this warning is ignored, it could result in death, serious injuries or da

7 USER’S MANUAL ActSafe PME This user’s manual will not replace instruction and traini

8 LIFTING DIRECTION HOW TO USE THE MACHINE Before the machine is started, check the po

9 - The user of the machine shall have received information about the machine’s funct