ActSafe PME Guía de usuario descargar pdf (Pagina 13)

WORK TECHNIQUE

Below is a detailed description of work technology as well as

required connections and products that should be used

together with the ActSafe PME. However, it should be

considered that this instruction does not replace any training

that is necessary for using this kind of equipment.

At the first opportunity (or, if you wish, at any use of the

equipment) on a support the “Line Thrower” is applied to

“rocket high” the guiding lines. The guiding line attachment

hole on the work rope is burned in by a soldering iron. The

end of guiding line is tied to the end of the working rope as

shown.

When using the device for first time on a mast the worker

has to climb up the mast using a full-body-harness and

rescue ropes in accordance with EN363 (Fall Arrest System).

If the mast/pole has a fixed guiding line, the sling has to be

mounted so that the guiding line:

a) is hanging down to the ground when wrapped around a

wire rope

b) is hanging freely after fixation to prevent it from wear and

tear.

When the guiding lines are positioned the working rope is tied

and lifted. The safety rope can be lifted simultaneously.

Tie a “ figure of eight” at the end of ropes and connect them by

a karabiner and slings. Affix as low as possible to the pole (two

separate fixation points). The safety rope should have the

CE-marking according to EN1891 and safety device by

EN353-2.

2. 3.

Or this method...

o tie an ” fi

eight”

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sin comentarios

ActSafe PME Guía de usuario Pagina 13